1. The safety operation regulations of the processing center must be observed.
2. Before work, wear protective equipment and tie cuffs as required. Scarves, gloves, ties and aprons are not allowed. Female workers should wear braids in their hats.
3. Check whether the tool compensation, machine tool zero point, workpiece zero point, etc. are correct before starting the machine.
4. The relative position of each button shall meet the operation requirements. Carefully compile and input NC programs.
5. Check the operation condition of the protection, insurance, signal, position, mechanical transmission part, electrical, hydraulic, digital display and other systems on the equipment. Cutting can be carried out under normal conditions.
6. Before the test run of the machine tool, the operation conditions of lubrication, mechanical, electrical, hydraulic, digital display and other systems should be checked, and cutting can be carried out under normal conditions.
7. After the machine tool enters the processing operation according to the program, the operator is not allowed to touch the moving workpiece, cutter and transmission part, and it is forbidden to transfer or take tools and other items across the rotating part of the machine tool.
8. When adjusting the machine tool, clamping the workpiece and cutter, and wiping the machine tool, it must be stopped.
9. Tools or other items shall not be placed on electrical appliances, operation cabinets and protective covers.
10. It is not allowed to remove iron filings directly by hand. Special tools should be used for cleaning.
11. In case of abnormal conditions and alarm signals, stop the machine immediately and ask relevant personnel to check.
12. It is not allowed to leave the work position when the machine tool is running. If you want to leave for some reason, put the workbench in the middle position and the cutter bar returns. You must stop the machine and cut off the power supply of the host machine.
