First of all, one of the common problems when using CNC milling is the reduction of surface finish when it will. There are many reasons for the poor or changing surface quality of workpieces.
The first cause is a tool that is too dull. A dull tool will deform the workpiece more, which will result in increased cutting forces, and as the deformation builds up, the cutting edge will go deeper into the part. If the chip suddenly breaks off, it will leave a small hole. This will result in a much lower surface finish.
Another contributing factor is the CNC milling strategy. Milling techniques are classified into two types: ascending and conventional. The first technique involves rotating the tool in the same direction as the table feed. Crawl milling involves impacting the tool and entering the workpiece, then slowly exiting the workpiece with minimal material (the surface generated after machining), resulting in a very good surface finish. Conventional milling occurs when the speed and feed direction are reversed. The tool enters the workpiece from the finishing surface in this manner. Due to mild vibration and procedure variance, the tool may cause minor damage to the finishing surface. However, this is sufficient to alter the ultimate surface finish.

A final cause of poor surface finish is improper or lack of coolant selection. Many people underestimate the role of coolants and lubricants; in fact, the use of the proper coolant lubricant can improve the quality of the entire surface.
It is essential that you maintain your cutting equipment, apply the suitable approach, and choose the proper coolant to get the best possible surface finish.
Then there's the usual issue of surface burns on CNC milling workpieces. Surface burns are burns on the machined part's surface. Burning indicates that the workpiece has overheated.
It is caused by inappropriate cutting parameters, which might result in workpiece flaws. Improper feed and speed selection can cause significant damage to the workpiece, the cutting tool, and even the machine.
Reducing the cutting speed to feed ratio is one solution to this problem. This lessens the temperature and slows down the machining process.
Another method is to increase the cooling rate of the process. In some extreme cases, such as titanium with poor thermal conductivity, both of these methods are necessary.










